Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. American Fork Roofing & Maintenance — leak-free skylight installation in American Fork.
The curb is the foundation of every skylight installation. We frame it between existing trusses or rafters with doubled lumber to carry the load. The roof deck opening is cut precisely — no oversizing that weakens the sheathing. The skylight flange seals to the curb, and the flashing system integrates the unit into the existing shingle field so water runs over the flashing, not under it.
Our Skylight Installation Process
Site Assessment
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Structural Prep
We cut the roof deck opening through the sheathing and shingles, then frame a structural curb between the rafters with doubled lumber. Headers distribute the load around the opening. The curb provides a solid, level base for the skylight unit.
Flashing & Waterproofing
Ice-and-water shield wrapped around the entire curb perimeter. Step flashing installed on all four sides, woven into the shingle courses. Counter-flashing at the top integrates with the shingles above. Sealant at every transition point. This flashing system is what prevents leaks — it's the most critical step.
Completion
Skylight unit set into the curb and flange sealed to the roof deck. Shingles re-laid around the unit with proper overlap. Inside, rigid insulation installed around the light shaft to prevent condensation. Interior trim finished. Watertight verified from the attic.
What American Fork Customers Say
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
Why Choose American Fork Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.
Code Compliant
Every skylight installation meets UT building code for structural framing, energy performance, and egress requirements. Permits pulled when required.